A Step-by-Step Guide to Installing a Toilet
Posted: Friday, March 16, 2007
by Bill Healey
Home improvement projects can be an intimidating task for many people. Often times, homeowners don’t want to risk doing damage to their house. Some people just lack the knowledge and experience about working on certain projects. I know a couple who own their own home and yet still calls the one father anytime something needs to be fixed.
1. The closet bend and toilet floor flange must be roughed in first. When replacing a toilet, you will need to scrape up the old wax gasket. A putty knife works well for this. Remove the old bolts from the floor flange and scrape the flange clean to prevent leaks at the base of the new bowl. If the old flange is cracked or broken, replace it with a new floor flange.
2. Position the floor flange so that the underside of the flange is at the level of the finished floor. (It is always best to install the finished floor so that it runs underneath the toilet.) You may need to use a piece of finished flooring material if the floor has not yet been installed. Now you can finish tightening the screws that hold the floor flange to the floor. Put a small level on the flange while tightening to be sure it is level.
3. Set the new floor bolts in plumber's putty and insert them through the flange, adjusting the bolts so they line up with the center of the drainpipe.
4. With the new toilet bowl turned upside down, position the new wax gasket over the toilet horn on the bottom of the bowl.
5. Apply plumber's putty around the entire bottom edge of the bowl.
6. Using the bolts as guides, lower the bowl into place over the flange. Press down firmly while giving a slight twist. It is important that you feel the toilet being pushed into the wax ring. If you do not feel this, the flange is set too low and you will not get a good wax seal between the flange and the horn (waste outlet). Also, if the wax ring is cold, it will not properly seat. You may need to warm it in the sun for awhile until it is pliable.
7. Use a level to level the bowl, adding shims where necessary. Also be sure the toilet is square and aligned with the wall. Then tighten the nuts and washers onto the bolts by hand.
8. Place the rubber tank cushion (if one is needed) into position on the rear of the bowl and fit the rubber gasket onto the flush valve opening on the bottom of the tank.
9. Position the tank over the bowl; then tighten the nuts and washers onto the mounting bolts.
10. Tighten the hold-down bolts at the base of the bowl with an adjustable wrench. Use your level to assure the bowl is still level.
11. Fill the decorative caps with plumber's putty and place them over the bolt ends. Seal the base of the toilet bowl with plumber's putty or silicone caulk.
12. Cut the end of your supply line stub out and attach a shut off valve. Then, connect the shutoff valve to the flexible tubing and connect the tubing to the bottom of the tank, where you will find a supply stub out.
Sticking to these steps correctly and in the right order will guarantee you a finished project which is done properly and promptly.
For more information on topics such as this, check out Magsforless at www.magsforless.com. They sell a variety of magazine subscriptions on home improvement with hundreds of other cheap magazines on any subject you choose. With an extensive list of magazine titles to choose from and the cheapest prices available, they stand out from the competition.
This Article has been viewed 1,368 times. (Not updated in real-time.)
No comments yet.We want your comments! If you can read this, you don't have javascript enabled, so you can't use this comment system. Please enable javascript.